|
|
Tarutis Jr, W. J., Stark, L. R., & Williams, F. M. (1999). Sizing and performance estimation of coal mine drainage wetlands. Ecological Engineering, 12(3-4), 353–372.
Abstract: The effectiveness of wetland treatment of acid mine drainage (AMD) was assessed using three measures of performance: treatment efficiency, area-adjusted removal, and first-order removal. Mathematical relationships between these measures were derived from simple kinetic equations. Area-adjusted removal is independent of pollutant concentration (zero-order reaction kinetics), while first-order removal is dependent on concentration. Treatment efficiency is linearly related to area-adjusted removal and exponentially related to first-order removal at constant hydraulic loading rates (flow/area). Examination of previously published data from 35 natural AMD wetlands revealed that statistically significant correlations exist between several of the performance measures for both iron and manganese removal, but these correlations are potentially spurious because these measures are derived from, and are mathematical rearrangements of, the same operating data. The use of treatment efficiency as a measure of performance between wetlands is not recommended because it is a relative measure that does not account for influent concentration differences. Area-adjusted removal accounts for mass loading effects, but it fails to separate the flow and concentration components, which is necessary if removal is first-order. Available empirical evidence suggests that AMD pollutant removal is better described by first-order kinetics. If removal is first-order, the use of area-adjusted rates for determining the wetland area required for treating relatively low pollutant concentrations will result in undersized wetlands. The effects of concentration and flow rate on wetland area predictions for constant influent loading rates also depend on the kinetics of pollutant removal. If removal is zero-order, the wetland area required to treat a discharge to meet some target effluent concentration is a decreasing linear function of influent concentration (and an inverse function of flow rate). However, if removal is first-order, the required wetland area is a non-linear function of the relative influent concentration. Further research is needed for developing accurate first-order rate constants as a function of influent water chemistry and ecosystem characteristics in order to successfully apply the first-order removal model to the design of more effective AMD wetland treatment systems.
|
|
|
|
Van Hille, R. P., Boshoff, G. A., Rose, P. D., & Duncan, J. R. (1999). A continuous process for the biological treatment of heavy metal contaminated acid mine water. Resour. Conserv. Recycl., 27(1-2), 157–167.
Abstract: Alkaline precipitation of heavy metals from acidic water streams is a popular and long standing treatment process. While this process is efficient it requires the continuous addition of an alkaline material, such as lime. In the long term or when treating large volumes of effluent this process becomes expensive, with costs in the mining sector routinely exceeding millions of rands annually. The process described below utilises alkalinity generated by the alga Spirulina sp., in a continuous system to precipitate heavy metals. The design of the system separates the algal component from the metal containing stream to overcome metal toxicity. The primary treatment process consistently removed over 99% of the iron (98.9 mg/l) and between 80 and 95% of the zinc (7.16 mg/l) and lead (2.35 mg/l) over a 14-day period (20 l effluent treated). In addition the pH of the raw effluent was increased from 1.8 to over 7 in the post-treatment stream. Secondary treatment and polishing steps depend on the nature of the effluent treated. In the case of the high sulphate effluent the treated stream was passed into an anaerobic digester at a rate of 4 l/day. The combination of the primary and secondary treatments effected a removal of over 95% of all metals tested for as well as a 90% reduction in the sulphate load. The running cost of such a process would be low as the salinity and nutrient requirements for the algal culture could be provided by using tannery effluent or a combination of saline water and sewage. This would have the additional benefit of treating either a tannery or sewage effluent as part of an integrated process.
|
|
|
|
Tsukamoto, T. K., & Miller, G. C. (1999). Methanol as a Carbon Source for Microbiological Treatment of Acid Mine Drainage. Water Res., 33(6), 1365–1370.
Abstract: Sulfate reducing passive bioreactors are increasingly being used to remove metals and raise the pH of acidic waste streams from abandoned mines. These systems commonly use a variety of organic substrates (i.e. manure, wood chips) for sulfate reduction. The effectiveness of these systems decreases as easily accessible reducing equivalents are consumed in the substrate through microbial activity. Using column studies at room temperature (23-26 degrees C), we investigated the addition of lactate and methanol to a depleted manure substrate as a method to reactivate a bioreactor that had lost >95% of sulfate reduction activity. A preliminary experiment compared sulfate removal in gravity fed, flow through bioreactors in which similar masses of each substrate were added to the influent solution. Addition of 148 mg/l lactate resulted in a 69% reduction in sulfate concentration from 300 to 92 mg/l, while addition of 144 mg/l methanol resulted in an 88% reduction in sulfate concentration from 300 to 36 mg/l. Because methanol was found to be an effective sulfate reducing substrate, it was chosen for further experiments due to its inherent physical properties (cost, low freezing point and low viscosity liquid) that make it a superior substrate for remote, high elevation sites where freezing temperatures would hamper the use of aqueous solutions. In these column studies, water containing sulfate and ferrous iron was gravity-fed through the bioreactor columns, along with predetermined methanol concentrations containing reducing equivalents to remove 54% of the sulfate. Following an acclimation period for the columns, sulfate concentrations were reduced from of 900 mg/l in the influent to 454 mg/l in the effluent, that reflects a 93% efficiency of electrons from the donor to the terminal electron acceptor. Iron concentrations were reduced from 100 to 2 mg/l and the pH increased nearly 2 units. (C) 1999 Elsevier Science Ltd.
|
|
|
|
Barton, C. D. (1999). Renovation of a failed constructed wetland treating acid mine drainage. Environmental Geology, 39(1), 39–50.
Abstract: Acid mine drainage (AMD) from abandoned underground mines significantly impairs water quality in the Tones Branch watershed in McCreary Co., Kentucky, USA. A 1022-m(2) surface-flow wetland was constructed in 1989 to reduce the I AMD effects, however, the system failed after six months due to insufficient utilization of the treatment area, inadequate alkalinity production and metal overloading. In an attempt to improve treatment efficiencies, a renovation project was designed incorporating two anoxic limestone drains (ALDs) and a series of anaerobic subsurface drains that promote vertical now or mine water through a successive alkalinity producing system (SAPS) of limestone beds overlain by organic compost. Analytical results from the 19-month post-renovation period are very encouraging. Mean iron concentrations have decreased from 787 to 39 mg l(-1), pH increased from 3.38 to 6.46 and acidity has been reduced from 2244 to 199 mg l(-1) (CaCO3 equivalent). Mass removal rates averaged 98% for Al, 95% for Fe, 94% for acidity, 55% for sulfate and 49% for Mn during the study period. The results indicate increased alkalinity production from limestone dissolution and longer residence time have contributed to sufficient buffering and metal retention. The combination of ALDs and SAPS technologies used in the renovation and the sequence in which they were implemented within the wetland system proved to be an adequate and very promising design for the treatment of this and other sources of high metal load AMD.
|
|
|
|
O'Sullivan, A. D., McCabe, O. M., Murray, D. A., & Otte, M. L. (1999). Wetlands for rehabilitation of metal mine wastes. Biology and Environment-Proceedings of the Royal Irish Academy, 99b(1), 11–17.
Abstract: Aspects of research work undertaken by the Wetland Ecology Research Group at University College Dublin are summarised here. Wastes from mining activities generally contain high concentrations of heavy metals and other toxic substances. Reclamation methods to treat these wastes include the use of wetlands, for revegetation of mine tailings under flooded conditions and for the treatment of tailings water. Both natural and constructed wetlands are frequently employed for the treatment of mine wastes. Through a complex array of plant, soil and microbial interactions contaminants, such as heavy metals and sulphates, can be successfully removed from wastewater. Suitable vegetation can stabilise the tailings sediment, thereby preventing it from being dust-blown or leached into the surrounding environment. Our research suggests that these two techniques for treatment of mine wastes are successful and economically viable.
|
|
