|
Zhuang, J. M. (2004). Lignor(TM) process for acidic rock drainage treatment. Environ. Technol., 25(9), 1031–1040.
Abstract: The process using lignosulfonates for acidic rock drainage (ARD) treatment is referred to as the Lignor(TM) process. Lignosulfonates are waste by-products produced in the sulfite pulping process. The present study has shown lignosulfonates are able to protect lime from developing an external surface coating, and hence to favor its dissociation. Further, the addition of lignosulfonates to ARD solutions increased the clotting and settling rate of the formed sludge. The capability of lignosulfonates to form stable metal-lignin complexes makes them very useful in retaining metal ions and thus improving the long-term stability of the sludge against leaching. The Lignor(TM) process involves metal sorption with lignosulfonates, ARD neutralization by lime to about pH 7, pH adjustment with caustic soda to 9.4 – 9.6, air oxidation to lower the pH to a desired level, and addition of a minimum amount of FeCl3 for further removal of dissolved metals. The Lignor(TM) process removes all concerned metals (especially Al and Mn) from the ARD of the Britannia Mine (located at Britannia Beach, British Columbia, Canada) to a level lower than the limits of the B.C. Regulations. Compared with the high-density sludge (HDS) process, the Lignor(TM) process has many advantages, such as considerable savings in lime consumption, greatly reduced sludge volume, and improved sludge stability.
|
|
|
Catalan, L. J. J., & Yin, G. (2003). Comparison of calcite to quicklime for amending partially oxidized sulfidic mine tailings before flooding. Environ Sci Technol, 37(7), 1408–1413.
Abstract: Flooding partially oxidized mine tailings for the purpose of mitigating further oxidation of sulfide minerals and generation of acid drainage is generally preceded by treatment with alkaline amendments to prevent releasing previously accumulated acidity to the water cover. This work compares the ability of calcite (CaCO3) and quicklime (CaO), two common amendments, to establish and maintain pH conditions and dissolved metal concentrations within environmentally acceptable ranges over long time periods. Although higher initial pH values were obtained with quicklime, the pH of quicklime treated tailings decreased over time. This was attributed to the low buffering capacity of quicklime treated tailings and to the consumption of hydroxide ions by incongruent dissolution of water-insoluble iron oxyhydroxysulfate minerals. In contrast, the pH of tailings treated with calcite increased initially and then remained stable at pH approximate to 6.7. This pH behavior was due to the lower reactivity of iron oxyhydroxysulfates with calcite, the increased buffering capacity provided by bicarbonate ions, and the incomplete dissolution of calcite. Overall, calcite was found preferable to quicklime for maintaining long-term neutral pH conditions in the treated tailings. With the exception of zinc, acceptable dissolved metal concentrations were achieved with calcite treated tailings.
|
|
|
Scholz, M. (2002). Mature experimental constructed wetlands treating urban water receiving high metal loads. Biotechnology Progress, 18(6), 1257–1264.
Abstract: The aim was to assess over 2 years the treatment efficiencies of vertical-flow wetland filters containing macrophytes and granular media of different. adsorption capacities. Different concentrations of lead and copper sulfate (constant for 1 year each) were added to urban beck inflow water in order to simulate pretreated (pH adjustment assumed) mine wastewater. After 1 year of operation, the inflow concentrations for lead and copper were increased from 1.30 to 2.98 and from 0.98 to 1.93 mg/L, respectively. However, the metal mass load rates (mg/m(2)/d) were increased by a factor of approximately 4.9 for lead and 4.3 for copper. No breakthrough of metals was recorded. Lead and copper accumulated in the biomass of the litter zone and rhizomes of the macrophytes. Furthermore, microbiological activity decreased during the second year of operation. Bioindicators such as ciliated protozoa and zooplankton decreased sharply in numbers but diatoms increased. In conclusion, the use of macrophytes and, adsorption media did not significantly enhance the filtration of lead and copper. Particulate lead is removed by filtration processes including straining. Furthermore, some expensive and time-consuming water quality variables can be predicted with less expensive ones such as temperature in order to reduce sampling costs.
|
|
|
Lawrence, R. (2002). Technology reduces sulphur compounds – A new way of treating acid mine drainage. Canadian Mining Journal, 123(7), 27.
|
|
|
Scholz, M. (2002). Performance comparison of experimental constructed wetlands with different filter media and macrophytes treating industrial wastewater contaminated with lead and copper. Bioresource Technology, 83(2), 71–79.
Abstract: The aim of this study was to investigate the treatment efficiency of passive vertical-flow wetland filters containing different macrophytes (Phragmites and/or Typha) and granular media with different adsorption capacities. Gravel, sand, granular activated carbon, charcoal and Filtralite (light expanded clay) were used as filter media. Different concentrations of lead and copper sulfate were added to polluted urban stream inflow water to simulate pretreated mine wastewater. The relationships between growth media, microbial and plant communities as well as the reduction of predominantly lead, copper and five-day biochemical oxygen demand (BOD5) were investigated. An analysis of variance showed that concentration reductions (mg 1(-1)) of lead, copper and BOD5 were significantly similar for the six experimental wetlands. Microbial diversity was low due to metal pollution and similar for all filters. There appears to be no additional benefit in using adsorption media and macrophytes to enhance biomass performance during the first 10 months of operation. (C) 2002 Elsevier Science Ltd. All rights reserved.
|
|