Abstract: In 1991, LTV Steel Mining decided to close an open-pit taconite mine in northeastern Minnesota using a passive-treatment approach consisting of limiting infiltration into the stockpiles and wetland treatment to remove metals. More than 50 Mt (55 million st) of sulfide-containing waste had been stockpiled adjacent to the mine during its 30 years of operation. Drainage from the stockpiles contained elevated levels of copper, nickel, cobalt and zinc. Nickel is the major trace metal in the drainages. Before the closure, the annual median concentrations ranged from 1.5 to 50 mg/L. Copper, cobalt and zinc are also present but they are generally less than 5% of the nickel values. Median pH levels range from 5 to 7.5, but most of the stockpile drainages have pH levels greater than 6.5. Based on the chemical composition of each stockpile, a cover material was selected. The higher the potential that a stockpile had to produce acid drainage, the lower the permeability of the capping material required. Covers ranged from overburden soil removed at the mine to a flexible plastic liner. Predictions of the reduction in infiltration ranged from 40% for the native soil to more than 90% for the plastic liner. Five constructed wetlands have been installed since 1992. They have removed 60% to 90% of the nickel in the drainages. Total capital costs for all the infiltration reduction and wetlands exceeded $6.5 million, but maintenance costs are less than 1% of those for an active treatment plant. Because mine-drainage problems can continue for more than 100 years, the lower annual operating costs should pay for the construction of the wetland-treatment systems within seven years.

Abstract: Covers are widely used as a means of controlling pollutant generation from sulfidic waste piles. To date, there has been little data available to test the effectiveness of such covers. Monitoring of two waste rock dumps at Rum Jungle over more than fifteen years has provided the opportunity to assess cover effectiveness in the medium term. For the first 9 years the infiltration rate through the cover on Whites dump was less than the design figure of 5 per cent of rainfall. In subsequent years, however, the rate has increased to between 5 and 10 per cent. In the first six years the infiltration rate through the cover on Intermediate dump was also less than 5 per cent. Unfortunately, further measurements had to be abandoned due to equipment malfunction in this dump. Oxygen and temperature profiles measured below the cover have been used to estimate the overall oxidation rate in the two dumps. This is between 30 and 50 per cent of the oxidation rate prior to installation of the cover. The effect these results have on pollutant loads in drainage in the long term depends on the nature of the control mechanisms in the system. If pollutant concentrations in drainage are determined by secondary mineralisation within the dumps then pollutant loads in the long term will be essentially proportional to any further increase in the infiltration rate. If the pollutant loads in drainage are largely determined by the overall oxidation rates then we can expect the pollutant loads from the two dumps to increase in the long term to a level about one third to one half of that prior to rehabilitation. In this context, 'long term' means about 40 years after installation of the cover system. Given the implications this work has for the use of soil covers, the following additional studies should be undertaken: A measurement program to quantify the pollution loads from Intermediate and Whites waste rock dumps. A program of computation, backed by acquisition of mineralogical data on the wastes, to address the question of controls on concentration and load in effluent from the two dumps. A program to determine the reason for the deteriorating performance of the covers at Rum Jungle.

Abstract: The performance of mine water treatment schemes, operated under the Coal Authority's national Minewater Treatment Programme, is summarised. Most schemes for which data are available perform successfully and remove over 90% iron. Mean area-adjusted iron removal rates for reedbed components of treatment schemes, range from 1.5 to 5.5 g Fe/m², with percentage iron removal rates ranging from 68% to 99%. In the majority of cases, calculated area-adjusted removal rates are limited by influent iron loadings, and the empirical sizing criterion for aerobic wetlands, based on American removal rates of 10 g Fe/m²day, remains a valuable tool in the initial stages of treatment system design and estimation of land area requirements. Where a number of schemes have required modification after becoming operational, due consideration must always be given to the potential for dramatic increases in influent iron loadings, and to how the balance between performance efficiency and aesthetic appearance can best be achieved. Continual review and feedback on the performance of treatment systems, and the problems encountered during design implementation, will enhance the efficiency and effectiveness of the Minewater Treatment Programme within the UK.