Ntengwe, F. W. (2005). An overview of industrial wastewater treatment and analysis as means of preventing pollution of surface and underground water bodies – The case of Nkana Mine in Zambia. Phys. Chem. Earth, 30(11-16 Spec. Iss.), 726–734.
Abstract: The wastewaters coming from mining operations usually have low pH (acidic) values and high levels of metal pollutants depending on the type of metals being extracted. If unchecked, the acidity and metals will have an impact on the surface water. The organisms and plants can adversely be affected and this renders both surface and underground water unsuitable for use by the communities. The installation of a treatment plant that can handle the wastewaters so that pH and levels of pollutants are reduced to acceptable levels provides a solution to the prevention of polluting surface and underground waters and damage to ecosystems both in water and surrounding soils. The samples were collected at five points and analyzed for acidity, total suspended solids, and metals. It was found that the pH fluctuated between pH 2 when neutralization was forgotten and pH 11 when neutralization took place. The levels of metals that could cause impacts to the water ecosystem were found to be high when the pH was low. High levels of metals interfere with multiplication of microorganisms, which help in the natural purification of water in stream and river bodies. The fish and hyacinth placed in water at the two extremes of pH 2 and pH 11 could not survive indicating that wastewaters from mining areas should be adequately treated and neutralized to pH range 6-9 if life in natural waters is to be sustained. < copyright > 2005 Elsevier Ltd. All rights reserved.
|
Perry, A., & Kleinmann, R. L. P. (1991). The use of constructed wetlands in the treatment of acid mine drainage. Natural Resources Forum, 15(3), 178–184.
Abstract: US government regulations require that all effluents from industrial operations, including mining, meet certain water quality standards. Constructed wetlands have proven to be useful in helping to attain those standards. Application of this biotechnology to mine water drainage can reduce water treatment costs and improve water quality in streams and rivers adversely affected by acidic mine water drainage from abandoned mines. Over 400 constructed wetland water treatment systems have been built on mined lands largely as a result of research by the US Bureau of Mines. Wetlands are passive biological treatment systems that are relatively inexpensive to construct and require minimal maintenance. Chemical treatment costs are reduced sufficiently to repay the cost of construction in less than a year. The mine waste water is typically treated in a series of excavated ponds that resemble small marsh areas. The ponds are engineered to facilitate bacterial oxidation of iron. Ideally, the water then flows through a composted organic substrate supporting a population of sulphate-reducing bacteria which raises the pH. Constructed wetlands in the US are described – their history, functions, construction methodologies, applicabilities, limitations and costs. -Authors
|
Rees, B., Bowell, R., Dey, M., & Williams, K. (2001). Passive treatment; a walk away solution? Mining Environmental Management, 9(2), 7–8.
|
Kuyucak, N. (2001). Acid mine drainage; treatment options for mining effluents. Mining Environmental Management, 9(2), 12–15.
|
Camus, M. (1997). Le traitement des eaux de mine desaffectees. Die Aufbereitung von Wässern aus stillgelegten Bergwerken. Treating water from closed mines. Mines et Carrieres, (Feb), 38–39.
Abstract: In einem alten französischen Bergwerk, in dem früher Blei und Silber abgebaut wurden, kam es nach dem Wiederanstieg des Grundwassers zu einer erhöhten Schwermetallbelastung von Quellgebieten, die einen Fluß mit Forellenbesatz schädigten. Zur Beseitigung dieser Grundwasserverunreinigung wurde das saure Grubenwasser mit erhöhten Eisen- und Zinkgehalten übertage gefaßt und einer Wasseraufbereitung unterzogen. In der für einen Durchsatz von 100 m(exp 3)/h konzipierten Wasseraufbereitung wurden die Schadstoffbestandteile durch Oxidation und anschließende Neutralisation mit Kalk (Anhebung des pH-Wertes auf 8,2 bis 8,3) gefällt, durch Zugabe eines Flockungsmittels gebunden und die Schlammbestandteile anschließend einem Eindicker und Filterpressen zugeführt. Der Kalkverbrauch wird mit 240 kg/d angegeben. Die tabellarisch zusammengestellten Analysenergebnisse zeigen, daß die Wasseraufbereitung einen sehr guten Wirkungsgrad hatte. Neben einer Anhebung des pH-Wertes von 6,5 auf 8,2 konnten die Schwermetallgehalte bei Fe von 22 mg/l auf 0,09 mg/l und bei Zn von 38 mg/l auf 0,4 mg/l abgesenkt werden.
|