|
|
Simmons, J., Ziemkiewicz, P., & Black, D. C. (2002). Use of Steel Slag Leach Beds for the Treatment of Acid Mine Drainage. Mine Water Env., 21(2), 91–99.
Abstract: Steel slag from the Waylite steel-making plant in Bethlehem, Pennsylvania was leached with acidic mine drainage (AMD) of a known quality using an established laboratory procedure. Leaching continued for 60 cycles and leachates were collected after each cycle. Results indicated that the slag was very effective at neutralizing acidity. The AMD/slag leachates contained higher average concentrations of Ba, V, Mn, Cr, As, Ag, and Se and lower average concentrations of Sb, Fe, Zn, Be, Cd, Tl, Ni, Al, Cu, and Pb than the untreated AMD. Based on these tests, slag leach beds were constructed at the abandoned McCarty mine site in Preston County, West Virginia. The leach beds were constructed as slag check dams below limestone-lined settling basins. Acid water was captured in limestone channels and directed into basins to leach through the slag dams and discharge into a tributary of Beaver Creek. Since installation in October 2000, the system has been consistently producing net alkaline, pH 9 water. The treated water is still net alkaline and has a neutral pH after it encounters several other acidic seeps downstream.
|
|
|
|
Skousen, J. G., Rose, A., Geidel, G., Foreman, J., Evans, R., & Hellier, W. (1998). Handbook of Technologies for Avoidance and Remediation of Acid Mine Drainage. Morgantown: The National Mine Land Reclamation Center.
Abstract: An array of techniques have been developed during the last several decades to abate or control pollution by acid mine drainage (AMD) from coal and metal mines. Although most of these techniques are successful in eliminating or decreasing the deleterious effects of AMD in some situations, they are unsuccessful in others. Due to the inherent variability between mines and environmental conditions, no one abatement or treatment technique is effective on all sites, and selection of the best method on each site is difficult given the array of methods available. The techniques also vary in the type and size of problem they are capable of handling. Their individual costs, effectiveness, and maintenance are also important considerations. Therefore, accurate information is needed to understand the limitations of the various methods and their response to various site variables. Continued research is imperative for field testing of existing technologies, as well as continued development of new technologies. At present, there is no authoritative guide or manual to assist in evaluating the best technique for a given situation. In order to continue to mine coal and other minerals without harming the environment, the best science and techniques must be identified and implemented in order to minimize the production of AMD. To accomplish this goal, the Acid Mine Drainage Technology Initiative (ADTI) was organized to promote communication among scientists and engineers dealing with AMD, and to develop a consensus on the identification and optimum usage of each method. The intent is to provide information on selection of appropriate techniques for specific problems that will ultimately lead to a higher level of success in avoidance of AMD and remediation of existing sources, at a savings in cost and staff time, and with greater assurance that a planned technique will accomplish its objective. This effort will result in enhancement of mine drainage quality, improvement in stream cleanup and its cost effectiveness, and development of a mechanism for technology transfer.
|
|
|
|
Blowes, D. W., Bain, J. G., Smyth, D. J., Ptacek, C. J., Jambor, J. L., Blowes, D. W., et al. (2003). Treatment of mine drainage using permeable reactive materials. Environmental Aspects of Mine Wastes, 31, 361–376.
|
|
|
|
Blowes, D. W., Ptacek, C. J., Benner, S. G., McRae, C. W. T., Bennett, T. A., & Puls, R. W. (2000). Treatment of inorganic contaminants using permeable reactive barriers. J Contam Hydrol, 45(1-2), 123–137.
Abstract: Permeable reactive barriers are an emerging alternative to traditional pump and treat systems for groundwater remediation. This technique has progressed rapidly over the past decade from laboratory bench-scale studies to full-scale implementation. Laboratory studies indicate the potential for treatment of a large number of inorganic contaminants, including As, Cd, Cr, Cu, Hg, Fe, Mn, Mo, Ni, Pb, Se, Tc, U, V, NO3, PO4 and SO4. Small-scale field studies have demonstrated treatment of Cd, Cr, Cu, Fe, Ni, Pb, NO3, PO4 and SO4. Permeable reactive barriers composed of zero-valent iron have been used in full-scale installations for the treatment of Cr, U, and Tc. Solid-phase organic carbon in the form of municipal compost has been used to remove dissolved constituents associated with acid-mine drainage, including SO4, Fe, Ni, Co and Zn. Dissolved nutrients, including NO3 and PO4, have been removed from domestic septic-system effluent and agricultural drainage.
|
|
|
|
Kepler, D. A., & Mc Cleary, E. C. (1994). Successive Alkalinity-Producing Systems (SAPS) for the Treatment of Acid Mine Drainage. Proceedings, International Land Reclamation and Mine Drainage Conference, 1, 195–204.
Abstract: Constructed wetland treatment system effectiveness has been limited by the alkalinity-producing, or acidity-neutralizing, capabilities of systems. Anoxic limestone drains (ALD's) have allowed for the treatment of approximately 300 mg/L net acidic mine drainage, but current design guidance precludes using successive ALD's to generate alkalinity in excess of 300 mg/L because of concerns with dissolved oxygen. “Compost” wetlands designed to promote bacterially mediated sulfate reduction are suggested as a means of generating alkalinity required in excess of that produced by ALD's. Compost wetlands create two basic needs of sulfate reducing bacteria; anoxic conditions resulting from the inherent oxygen demand of the organic substrate, and quasi-circumneutral pH values resulting from the dissolution of the carbonate fraction of the compost. However, sulfate reduction treatment area needs are generally in excess of area availability and/or cost effectiveness. Second generation alkalinity-producing systems demonstrate that a combination of existing treatment mechanisms has the potential to overcome current design concerns and effectively treat acidic waters ad infinitum. Successive alkalinity-producing systems (SAPS) combine ALD technology with sulfate reduction mechanisms. SAPS promote vertical flow through rich organic wetland substrates into limestone beds beneath the organic compost, discharging the pore waters. SAPS allow for conservative wetland treatment sizing calculations to be made as a rate function based on pH and alkalinity values and associated contaminant loadings. SAPS potentially decrease treatment area requirements and have the further potential to generate alkalinity in excess of acidity regardless od acidity concentrations.
|
|
