Eger, P., Melchert, G., Antonson, D., & Wagner, J. (1993). Magnesium hydroxide as a treatment for acid mine drainage in northern Minnesota. In B. A. Zamora, & R. E. Connolly (Eds.), Proceedings of the Annual National Meeting – American Society for Surface Mining and Reclamation, vol.10 (pp. 204–217). The challenge of integrating diverse perspectives in reclamation.
Abstract: Three alkaline materials were investigated for their suitability to treat acid mine drainage generated by a research facility located at a remote site in northern Minnesota. The materials investigated were hydrated lime, sodium hydroxide, and magnesium hydroxide. All three reagents were successful at raising pH and removing trace metals from the drainage, but the magnesium hydroxide had the added benefit of producing a maximum pH of approximately 9.5, while the other two reagents resulted in pH values of 12 and greater. In addition, the magnesium hydroxide was available as a high solid content slurry (58%) which simplified application and handling, and which produced the lowest volume of sludge of the materials tested.
|
Benzaazoua, M., & Bussiere, B. (1999). Desulphurization of tailings with low neutralizing potential; kinetic study and flotation modeling. In D. Goldsack, N. Belzile, P. Yearwood, & G. Hall (Eds.), Sudbury '99; Mining and the environment II; conference proceedings.
Abstract: Environmental desulphurization is an attractive alternative for acid generating tailings management as demonstrated during the last few years. In fact, such process placed at the end of the primary treatment circuit allows to reduce greatly the amount of problematic tailings by concentrating the sulphidic fraction. Moreover, the desulphurized tailings (non-acid generating) have the geotechnical and environmental properties for being used as fine material in a cover with capillary barrier effects. To produce desulphurized tailings, non selective froth flotation is the most adapted method as shown in many previous works. Desulphurization level is fixed by tailings sulphur content (or sulphide content) and neutralization potential NP. The final residue should have enough NP to compensate for his acid generating potential AP. In this paper, the authors present the results of laboratory tests conducted in Denver cells for studying the sulphide flotation kinetics of four mine tailings which are characterized by a weak neutralization potential (under 37 kg CaCO (sub 3) /t). Tailings 1, 2, 3 and 4 contain respectively 5.27, 10, 4.25 and 16.9 sulphur Wt. %. Tailings 1 and 2 are cyanide free and are well floated at pH around 11 by using amyl xanthate as collector. Collector dosage was optimized for these tailings and the results show that Tailing 2 need more collector. However, Tailings 3 and 4, which come from a gold cyanidation process, could not provide good sulphide recovery with xanthate collector because of the pyrite depression. To overcome this problem, amine acetate was used successfully but induces important entrainment. The consumption of this collector was also optimized. The results of kinetic tests and collector dosage were combined and modeled to establish relationships which allow to estimate the desulphurization performances.
|
Smit, J. P. (1999). (R. Fernández Rubio, Ed.). Mine, Water & Environment. Ii: International Mine Water Association.
|
LaPointe, F., Fytas, K., & McConchie, D. (2005). Using permeable reactive barriers for the treatment of acid rock drainage. International journal of surface mining, reclamation and environment, 19(1), 57–65.
Abstract: Acid mine drainage (AMD) is the most serious environmental problem facing the Canadian mineral industry today. It results from oxidation of sulphide minerals (e.g. pyrite or pyrrhotite) contained in mine waste or mine tailings and is characterized by acid effluents rich in heavy metals that are released into the environment. A new acid remediation technology is presented, by which metallurgical residues from the aluminium extraction industry are used to construct permeable reactive barriers (PRBs) to treat acid mine effluents. This technology is very promising for treating acid mine effluents in order to decrease their harmful environmental effects
|
Arnekleiv, J. V., & Storset, L. (1995). Downstream effects of mine drainage on benthos and fish in a Norwegian river; a comparison of the situation before and after river rehabilitation. Heavy metal aspects of mining pollution and its remediation, 52, 35–43.
Abstract: Parts of the Norwegian river Gaula are strongly polluted from former mining activity in the area. In the most polluted parts of the river the concentration levels of Cu and Zn in 1986-1987 were up to 155 mu g l (super -1) and 186 mu g l (super -1) , respectively. In 1989 the spoil heaps in the mining area were covered with protective layers of moss-covered plastic. In 1991-1992 the concentration levels of Cu and Zn had decreased by 75% and 65%, respectively. Animal life in the polluted area seemed to be strongly affected by the trace metals in 1986-1987. The 1991-1992 results showed a marked increase in the number of species and in the number of individuals of each species of Ephemeroptera and Plecoptera, compared with the results from 1986-87. Good correlations were found between the concentrations of Cu in the water and both the number of species and the number of individuals of Ephemeroptera and Plecoptera. Analysis of the species Baetis rhodani, Diura nanseni and Rhyacophila nubila showed an average total dry weight content of Cu up to 264 mu g g (super -1) , of Zn up to 1930 mu g g (super -1) and of Cd up to 16 mu g g (super -1) . The contents of the three trace metals were significantly different from one species to another and in part between the stations for each species. In 1987 trout died after an exposure of one to two days on three test sites in the river, whereas in 1991-1992 40-75% of the trout survived an exposure period of several weeks at two of the sites. Electrofishing in 1991-1992 indicated recolonization of trout in the lower parts of the former affected and uninhabitable area.
|